Power Supply for M2/M3 M2 3D Printer With these measurements

With these measurements

but is much easier to maintain adhesion on polyimide film

Please note that rails and carriages are matched at the factory where they're produced

it does have a limited lifespan

The BL Touch Probe is compatible with:

Power Supply for M2/M3 M2 3D Printer With these measurementsFeaturing a powder coated, stainless steel case with a current of 18. 8 A, this power supply provides a massive amount of power in order to heat your Heated Build Platform (HBP). Since November 2013 the MakerGear M2 has run on a 24 volt power supply, which includes an adjustment switch allowing for the use of both 100 130 V and 200 240 V wall power. If you ordered your M2 3D printer prior to November 2013, you will first need to install our "Power